Before starting the CNC vertical lathe, we need to consider some precautions and sequences. These steps not only ensure the safe and stable operation of the equipment, but also protect the life and performance of the equipment. The following is the correct sequence for starting up a CNC vertical lathe. Let us learn about it together.

First of all, we need to ensure that all circuits of the CNC vertical lathe are well connected and all switches need to be closed. Next, we need to ensure that the air pipelines of the CNC vertical lathe air compressor and pneumatic components are completely connected so that sufficient pressure support can be provided when the machine is working.

Secondly, start the "clearing operation". In this step, we need to clear all old data in the CNC vertical lathe control system to avoid interference between old data and new data. Normally, we need to perform a zeroing operation to clear the last time the machine was run.

The third step is to perform the jamming (tool magazine) operation. We need to place all the tools in designated locations and number them so that tools can be replaced quickly while the machine is working. We need to make sure that all the tools have been put into the jam in the correct order, and then place the jam in the designated position on the machine.

The fourth step is to perform inspection operations on the CNC machine tool. During this process, we need to check whether all electrical components are intact. At the same time, it is also necessary to check the replenishment of hydraulic components to ensure that the machine can provide sufficient hydraulic support when working. In addition, we also need to check whether the CNC system is operating normally to avoid accidents caused by system failure.

The machine starts the operation sequentially. The first step is to turn on the power. After confirming that all inspection operations are completed, we need to gradually turn on the CNC system, hydraulic system, and air system, and then wait for all systems to start normally. Then we need to initialize the CNC vertical lathe equipment. And after confirming that there are no abnormalities, we can press the start button to start the machine's work operations.

Therefore, the above is the correct sequence for starting up the CNC vertical lathe. If we follow the above steps, we can ensure the safe and stable operation of the equipment, and at the same time, we can better protect the life and performance of the machine and improve production efficiency. When we use CNC vertical lathe equipment, we should master these skills to avoid abnormal conditions in the machine due to some common problems.