When operating a CNC vertical lathe, there are several key considerations to keep in mind to ensure a safe and efficient process. The following are the precautions when operating CNC vertical lathe:

1. Familiar with the machine: Before operating the CNC vertical lathe, you must be familiar with and understand the structure and performance of the CNC vertical lathe, including the functions and operation methods of each component.

2. Lubrication and cleaning: Before using the CNC vertical lathe, perform necessary lubrication on the CNC vertical lathe and keep the oil passages clear. At the same time, make sure to clean certain key components of the CNC vertical lathe to prevent failure or loss of accuracy due to impurities.

3. Inspection and trial operation: Before starting the CNC vertical lathe, all parts of the CNC vertical lathe should be carefully inspected. After that, let the machine run dry for about 10 minutes to observe whether there are any abnormalities. Only after confirming that everything is normal can formal processing work begin.

4. Safe operation: When operating a CNC vertical lathe, it is strictly prohibited to wear gloves, and ensure that the clothes, collars and cuffs of the work clothes are fastened. At the same time, avoid touching the rotating spindle, workpiece or other moving parts with your hands or other means.

5. Tool and workpiece handling: The rough surface of the CNC vertical lathe workpiece cannot be placed directly on the work surface, but should be supported by a pad or screw top. When the CNC vertical lathe is aligning the workpiece, the worktable can only be inched to rotate at a low speed. In addition, it is prohibited to install or remove tools while the spindle is rotating to prevent accidents.

6. Speed change and parking: When the CNC vertical lathe changes speed, the joystick must be pushed to the specified position. If the gears are not meshing well, they should be adjusted by micro-movement rather than forced operation. When it is necessary to stop, you should first stop the vehicle and turn off the power switch before leaving the operating position.

7. Civilized production: During the entire operation process of CNC vertical lathes, regulations on safe and civilized production should be observed to ensure that the working environment is clean and tidy and the equipment is in good condition.

These considerations cover key aspects of CNC vertical lathe operation, from the preparation phase through actual operation, to safety and maintenance. Following these recommendations will not only improve processing efficiency but also ensure operator safety.