1. Environmental requirements. The orientation of the vertical machining center should be away from the vibration source, to prevent the influence of direct sunlight and thermal radiation, and to prevent the influence of moisture and air flow. If there is a vibration source near the CNC machine, an anti-vibration groove should be set around the machining center. Otherwise, it will directly affect the processing accuracy and stability, form poor contact of electronic components, form problems, and affect the reliability of the processing center.

Second, the power requirements. The general machining center is installed in the mechanical workshop, which not only changes the ambient temperature, but also has poor operating conditions, many varieties of mechanical and electrical equipment, and the power grid is shaken. Therefore, the orientation of the machining center requires strict control of the power supply voltage. The power supply voltage must be within the promised range and remain relatively stable. Otherwise, the normal operation of the CNC system of the machining center will be affected.

Third, the temperature conditions. The ambient temperature of the CNC machining center is less than 30 degrees, and the relative temperature is less than 80%. Generally speaking, the CNC electric control box is equipped with an exhaust fan or cooling fan inside, so that the electronic components, especially the processing unit, adhere to a constant working temperature or a small temperature difference. Excessive temperature and humidity can lead to reduced life of control system components and lead to the addition of defects. Temperature and humidity rise, and dust build-up can cause bonding and short circuits on the integrated circuit board.

Fourth, when using the machining center, the user does not agree to arbitrarily change the parameters set by the manufacturer in the control system. The setting of these machining center parameters is directly related to the dynamic characteristics of the individual components of the machining center. Only the value of the void compensation parameter can be adjusted according to the actual situation.