Horizontal machining centers should be installed away from the source of the earthquake, away from direct sunlight, thermal radiation and moisture. If there is a seismic source near the installation site of the horizontal machining center, anti-vibration grooves should be set around the horizontal machining center. If the anti-vibration groove is not installed, it will directly affect the machining accuracy and stability of the horizontal machining center, and over time, it will affect the poor contact and failure of electronic components, and affect the reliability of the horizontal machining center.

Voltage and current are strictly controlled.

The horizontal machining center is generally installed in the processing workshop, and the processing workshop has many mechanical equipment, which will inevitably lead to large fluctuations in the power grid. Therefore, the installation location of the horizontal machining center must strictly control the voltage and current of the power supply. The voltage and current of the power supply must be controlled within the allowable range of the horizontal machining center. The voltage and current of the power supply must be kept stable, otherwise it will directly affect the horizontal machining center. The machining center is operating normally.