Cleaning fully automatic CNC machine tools is an important step to maintain their good operating condition and extend their service life. The following are general cleaning steps, but please note that before cleaning, you should carefully read the machine tool's manual to ensure that the manufacturer's recommendations and guidance are followed.

1. Power outage and shutdown:

Before cleaning the CNC machine tool, make sure that the CNC machine tool is powered off and in a shutdown state. This is for safety reasons and to avoid unexpected mechanical movements during cleaning.

2. Clean surface dust and debris:

CNC machine tools use a clean, soft cloth or brush to clean dust, dirt and debris from the outer surface of the machine tool. You can use an air compressor or hair dryer to blow the dust away.

3. Clean the guide rail and screw:

CNC machine tools use a clean cloth to wipe the guide rails and lead screws to make sure they are free of dust or debris. Appropriate lubricants or detergents can be used to clean and ensure that the lubrication system is working properly.

4. Clean the cooling system:

CNC machine tool cleaning and cooling system, including coolant tank, cooling pipes and nozzles. To ensure that the coolant is flowing smoothly, use a special coolant cleaner.

5. Check the lubrication system:

CNC machine tools check the lubrication system to ensure that the oil is clean and the oil circuit is smooth. If contaminated or cloudy lubricant is found, it should be replaced and lubricated as recommended in the machine tool manual.

6. Clean the tool magazine and tools:

If the CNC machine tool is equipped with a tool magazine, clean the tools in the tool magazine and check the wear of the tools. If necessary, replace severely worn tools.

7. Check the electrical system:

CNC machines check connections to electrical systems to ensure they are secure. Check electrical components for obvious damage or wear and repair or replace them in time.

8. Clean the filter:

Clean or replace the filters on CNC machine tools, including air filters and hydraulic oil filters. This helps maintain system cleanliness and stability.

9. Clean up waste and chips:

CNC Machine Clean the chip collector and waste bin of your CNC machine. Make sure these parts are clean to prevent build-up from affecting normal machine operation.

10. Safety precautions:

When cleaning CNC machine tools, please pay attention to safety and ensure that you do not accidentally touch the moving parts of the machine tool. Follow the cleaning and maintenance guidelines provided in the machine tool manual.

During the cleaning process, it is very important to follow the CNC machine tool's instruction manual and manufacturer's recommendations to ensure proper cleaning methods and the use of appropriate cleaning agents.